Jura IMPRESSA F8 Service Manual download pdf (Page 21)

2 Preparation

E You can also permanently set the amount of water for all spe-

ciality coffees and hot water in programming mode (see

Chapter 4 ‘Permanent settings in programming mode –

Adjusting the product settings’).

You can adjust the grinder on a continuous scale to suit the degree

of roast of your coffee.

If you adjust the consistency of grind when the grinder is not oper-

ating, the grinder adjustment switch could be damaged.

T Only adjust the consistency of grind when the grinder is run-

ning.

The consistency of grind is correct if the coffee flows regularly from

the coffee spout. In addition a fine, thick crema forms.

Example:Proceed as follows to change the consistency of grind

during the preparation of an espresso.

T Place a cup under the coffee spout.

T Open the storage compartment cover.

T Press the ‘Espresso’ button to start preparation.

T Turn the grinder adjustment switch to the desired position

while the grinder is running.

The preset amount of water flows into the cup. Preparation

stops automatically.

T Close the storage compartment cover.

To obtain a perfect water flow, use the hot-water nozzle. You can find

the hot-water nozzle under the cover of the storage compartment.

There is a danger of scalding from hot water splashes.

T Avoid direct contact with the skin.

Example:Proceed as follows to prepare hot water.

Precondition:‘Please select product’ is displayed.

T Carefully remove the fine foam frother from the Connector

System

by twisting slightly.

Adjusting the grinder

CAUTION

Hot water

CAUTION

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 55 56

No comments

Jura IMPRESSA F8 Service Manual Page 21